Name: Epson L18050 Series
Brand: Epson
Rating: 5 (1 reviews)

To Next Page

To Previous Page

If you do not know where the [WPS] button is, or there are no buttons on the wireless router, see the

documentation provided with your wireless router for details.

2. Hold down the

button on the printer for at least 5 seconds until the light and the light ash

alternately.

e connection setting will start. When a connection is established, the

light turns on.

Note:

e

printer is in a connection error status when the

light and the light

ash

simultaneously.

Aer

clearing the

printer error by pressing the

button on the printer, reboot the wireless router, place it close to the printer and try

again. If it still does not work, print a network connection report and check the solution.

Making Wi-Fi Settings by PIN Code Setup (WPS)

You can connect to an wireless router by using a PIN code that is printed on the network status sheet. You can use

this method to set up if an wireless router is capable of WPS (Wi-Fi Protected Setup). Use a computer to enter a

PIN code into the wireless router.

1. Load papers.

2. Hold down the

button on the printer for at least 5 seconds.

e network status sheet is printed.

Note:

If you release the

button within 5 seconds, a network connection report is printed. Note that PIN code information

is not printed on this report.

3. While holding down the button, press the button until the light and the light

ash

alternately.

4. Use your computer to enter the PIN code (an eight digit number) printed on [WPS-PIN Code] column of the

network status sheet into the wireless router within two minutes.

When a connection is established, the

light turns on.

In These Situations

Re-Setting the Network Connection

Making Wi-Fi Settings from the Control Panel

Questions and Answers:

Need help?

Do you have a question about the Epson L18050 Series and is the answer not in the manual?

Epson L18050 Series Specifications

General