EasyManuals Logo

Epson PowerLite 4100 User Guide

Epson PowerLite 4100
124 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #88 background imageLoading...
Page #88 background image
88 Solving Problems
Flashing green The air filter may be clogged. Clean or replace the air filter as
described on pages 74 to 78.
Red or
flashing red
There is a problem with the projector. Check the other two lights and
the information on page 88 to diagnose the problem.
Flashing orange It’s time to replace the lamp. See page 78 for instructions. If you
continue to use the lamp after the replacement warning, there is an
increased possibility that the lamp may break.
Flashing orange Rapid cooling is in progress. Although this is not an abnormal
condition, projection will stop automatically if the temperature rises
higher. Make sure there is plenty of space around and under the
projector for ventilation, and that the vents are clear.
The air filter may be clogged. Clean or replace the air filter as
described on pages 74 to 78.
Red The projector is overheating, which turns the lamp off automatically.
Wait until the projector switches to standby mode (about 5 minutes).
Make sure the room temperature is not outside the required
temperature range of the projector (see page 108), and there is
plenty of space around and under the projector for ventilation.
The air filter may be clogged. Clean or replace the air filter as
described on pages 74 to 78.
If you’re using the projector above an altitude of 4,900 feet (1,500
meters), turn on High Altitude Mode in the Operation menu (see
page 67).
If the projector continues to overheat after you clean the air filter, the
problem may be caused by damage to the cooling fan or
temperature sensor. Contact Epson for help as described on
page 97.
Warning: Except as specifically explained in this User’s Guide, do
not attempt to service this product yourself.
Flashing red Power is cut off because of an internal problem. Unplug the power
cord and contact Epson for help, as described on page 97.
Flashing red
Flashing red There is a problem with the fan or temperature sensor. Stop using
the projector, disconnect the power cord, and contact Epson as
described on page 97.
Status lights (continued)
Light Status Description

Table of Contents

Other manuals for Epson PowerLite 4100

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Epson PowerLite 4100 and is the answer not in the manual?

Epson PowerLite 4100 Specifications

General IconGeneral
BrandEpson
ModelPowerLite 4100
CategoryProjector
LanguageEnglish

Related product manuals