Using the Printer Software for Macintosh
5-17
2. Click the
Margins
button. The following dialog box opens
3. Specify which edge of the paper the binding will be on. You
can choose between
Left
,
Top
, and
Right
.
4. Specify the width of the binding margin by entering a value
in the Binding Margin text box. You can specify a value
between 3 mm and 30 mm.
Note:
The actual binding margin may vary, depending on your
application. Experiment by printing a few sheets using different
binding margin values before printing the entire job; otherwise, the
results may differ from what you expect.
5. Click
OK
to return to the Page Setup dialog box, then click
OK
to save your settings.
6. Load paper in the sheet feeder, then send the print job from
your application. While the printer is printing the odd-
numbered pages, instructions are displayed which explain
how to reload the paper correctly.
7. Follow the instructions to reload the paper, or reload the
paper as shown in the illustration below.
Note:
❏
The paper may curl during printing, depending on the amount
of ink used to print text and images. Flatten it or curl it slightly
toward the opposite side before printing on the other side of the
paper.
To Next Page
Loading...
