Maintenance
9-13
Transporting the Printer
If you need to transport your printer, carefully prepare and repack
it using the original box (or a similar box that the printer fits
snugly into) and packing materials. Follow the steps below.
1. Open the printer cover and make sure that the print head is
in the home (far right) position. If it is not, turn on the printer
and wait until the print head returns to the home position.
Then, turn off the printer and close the printer cover.
c
Caution:
Leave the ink cartridges installed when you transport the
printer. Removing the cartridges during transport can
damage the printer.
2. Unplug the power cord from the electrical outlet, then
disconnect the interface cable from the printer.
3. Remove the paper from the sheet feeder, then remove the
paper support.
4. Open the printer cover again. Secure the ink cartridge holder
to the printer with tape as shown below, then close the printer
cover.
5. Push in the output extension tray, then raise the output tray.
6. Attach the protective materials to both sides of the printer.
To Next Page
Loading...
Need help?
General