1-2
Paper Handling
3. Load the stack of paper in the sheet feeder with the printable
side up and the right edge of the paper resting against the
right edge guide. Then slide the left edge guide against the
left edge of the paper.
Note:
❏
Always load paper into the sheet feeder short edge first.
❏
Make sure that the paper stack fits under the arrow mark inside
the edge guide.
Loading Special Paper and Other Media
You can achieve good results with most types of plain bond paper.
However, using coated paper and glossy film will result in higher
quality printouts because these types of media absorb smaller
amounts of ink.
EPSON provides special type of media that are formulated for the
ink used in EPSON ink jet printers. EPSON recommends using
media that is distributed by EPSON to ensure high-quality results.
See “Media types” on page 11-4 for a complete list of these
products.
To Next Page
Loading...
Need help?
General