Paper Handling
1-3
When loading special media that is distributed by EPSON, read
the instruction sheets packed with the media first and keep the
points listed below in mind.
❏
Make sure that the printable side of the paper is facing up
when loading media into the sheet feeder. See the instruction
sheets packed with the media to determine which side is the
printable surface. Some types of media have cut corners to
help identify the correct loading direction, as shown in the
illustration.
Note:
If you extend the printable area by selecting
Maximum
as the
Printable Area setting in the printer driver, the cut corner on special
paper may mar your printout.
❏
Make sure that the paper stack fits under the arrow mark that
is located on the inside surface of the left edge guide.
cut corner
printable
side up
To Next Page
Loading...
Need help?
General