3-50
Using the Printer Software for Windows
Note:
You may be unable to use DMA transfer on some computers even
after you make the settings described above. Consult your computer
maker for information on the DMA transfer capabilities of your
computer.
Making Configure LPT Port settings (for Windows
NT 4.0 only)
Note:
Port settings for Windows NT 4.0 are complicated and should only be
made by an experienced user with administrative privileges.
If your computer has a parallel port that supports ECP mode, you
can make certain print speed settings in the Configure LPT Port
dialog box. Before making settings, make sure that ECP mode has
been selected in your computer settings. For details about ECP
mode, see your computer manual.
To Next Page
Loading...
