Chapter 2 Setup
61
2
Setup
This chapter describes setup and installation of the product and peripherals.
When You Use This Printer for the First Time
Ink charging and media position detection setting are necessary before you use this printer for
the first time.
Follow the steps below.
1
Load the roll paper.
For details, see Loading/Replacing the Roll Paper on page 79.
2
Turn on the printer.
3
Load a new ink cartridge.
For details, see Loading/Replacing the Ink Cartridge on page 66.
• Ink charging starts after the ink cartridge cover is closed.
• When the ink cartridge is installed for the first time, the printer takes
approximately 8 minutes for ink charging.
The POWER LED flashes during
ink charging. Do not turn
off the printer or open the roll paper cover or the ink car-
tridge cover.
If the power is turned off, the roll paper cover is opened, or
the ink cartridge cover is opened during ink charging, ink
charging will restart from the beginning and an extremely
large amount of ink will be cons
umed.
• When ink charging finishes, the POWER LED stops flashing and stays on.
4
Set the media position detection of the printer for the paper type you
will be using.
For details, see 2. Setting for media position detection on page 82.
Do not turn on the printer power until installation of the printer driver is completed.
To Next Page
Loading...
Need help?
General