Chapter 2 Setup
97
2
5. Loading the fanfold paper and turning on the printer
1
Turn the power on.
2
After the Power LED stops flashing and lights, insert the paper into the
paper slot with the print surface facing upward until it is pulled into inside
the printer (approximately 100 mm). The paper is automatically fed.
3
Place the paper straight at least 40 mm from the printer.
When paper set operation at the paper cover close is set as “Media Loading Method (with
Cutting)” of [Media Loading Settings] on [Maintenance And Utilities] tab on the printer
driver, paper is automatically cut after the paper is fed.
To Next Page
Loading...
