45
Chapter 3 Advanced Usage
3
Reduction ratio of character height (68* model (ANK) only)
•Does not reduce
• Reduces 25%
• Reduces 50%
• Reduces 75%
• Reduces 75% and shortens character height
• Reduces the most and shortens character height
Auto image data scaling
• Nearest neighbor interpolation: Shrink the image data by 82%, keeping the aspect ratio.
• Cut off both sides: Cut off 46 dots from the edge of both sides of the image data.
• Cut off the right side: Cut off 92 dots from the right side of the image data.
• Cut off the left side: Cut off 92 dots from the left side of the image data.
• None: Actual size image data is defined or printed
Selection of the media type detection method
• Auto detection (default setting)
• Fixed to liner-free label paper
• Fixed to continuous paper without black marks
Amount of top margin by backfeed
This function is enabled when the selection of paper removal standby is set to "Enabled".
Selectable from 4.0 to 14.0 mm (in increments of 0.5 mm)
Default setting: 4 mm
• The printing and autocutting positions change depending on the paper type or the
software setting. ("Printing and Cutting Positions With Software Setting" on page 94)
•
Some selections are unavailable in the self-test mode. Use the memory switch setting
utility.
• This function has the following restrictions:
* The print-start time will be late.
* The print-result may have a blank line.
• This function is not available, if the data is less than 92 dots.
• The printing and autocutting positions change depending on the paper type or the
software setting. ("Printing and Cutting Positions With Software Setting" on page 94)
•
To set the function using the software setting mode, select [11. Top margin reduction] -
[11.1 when Paper removal standby is invalid].
To Next Page
Loading...
