96
Pattern B
Top margin of next label
SW setting
Paper
Paper removal standby Disabled
Stop position for cutting Arbitrary stop
position
Specific stop position
Auto top margin scaling Disabled Disabled
Liner-free label
paper
MSW6-1 Cut at black
mark position
4 to 14 mm
{0.16 to 0.55”}
Paper width 40 mm: approx. 14 mm {0.55”}
Paper width 80 mm: approx. 16 mm {0.63”}
• If the printer has received print data for the next label at the time of autocutting, the printer
performs autocutting at the position specified by command.
When the printer has not received print data for the next label, the printer automatically
feeds the paper to the specific stop position (fixed at the factory before shipping) below
the end-of-printing position, and performs autocutting. This may make the bottom margin
larger than the one based on the position where autocutting is set.
• The specific stop position is determined by the position where a black mark is detected.
Therefore, if the autocutting position is close to the specific stop position, the printer feeds
the paper to the next specific stop position and performs autocutting, due to paper slack or
variations in the paper, or differences in an individual printer.
• When autocutting is executed by an autocutting command along with paper feeding,
autocutting is performed after paper is fed to the specific stop position that is below the
paper feed position specified by command.
• For information on continuous multiple label printing, see "Pattern C" on page 97.
Actual autocut position
After feeding the paper to the specific stop
position specified by the factory setting,
the printer automatically performs
autocutting.
Position where autocutting is set
(Specified by command)
End of printing
To Next Page
Loading...
