Epson TM-T88 Series User Manual

95
Appendix
Pattern A
Top margin of next label
SW setting
Paper
Paper removal standby Enabled Disabled
Stop position for cutting
-
Arbitrary stop
position
Specific stop position
Auto top margin scaling - Disabled Disabled
Liner-free label
paper
MSW6-1 Cut at black mark
position
4 mm
{0.16”}
Approx. 14 mm
{0.55”}
Paper width 40 mm:
approx. 24 mm {0.94”}
Paper width 80 mm:
approx. 26 mm {1.02”}
• Autcutting is performed at the black mark position that is below the end-of-printing
position. If the autocutting position is close to the black mark, the black mark may be
skipped and autocutting may be performed at the next black mark position due to paper
slack or variations in the paper, or differences in an individual printer.
• When autocutting is executed by an autocutting command along with paper feeding,
autocutting is performed at the black mark position that is below the position where
autocutting is set.
• For information on continuous multiple label printing, see "Pattern D" on page 98.
Actual autocut position
(Black mark position)
Position where autocutting is set
(Specified by command)
End of printing
Back (non-printing side)

Epson TM-T88 Series Specifications

General

Print Method	Thermal line printing
Interfaces	USB, Serial, Ethernet
Auto Cutter	Yes
Paper Width	80 mm / 58 mm (with paper width guide)
Power Supply	Internal (some models may use external)