Chapter 3 Application Development Information
109
3
Memory Switch Setting Mode
You can configure the memory switches (customized values) of the printer.
•Print density
•Auto reduction of the amount of paper to use
•Autocutting of paper while the cover is closed
•Paper width
•Default value of character code page/international character set
•Auto replacement of font
•Power supply capacity
Follow the steps below to run this mode.
1
Close the roll paper cover.
2
Turn on the printer while pressing the Feed button.
The printer prints current status of the printer.
3
After the printing has been completed, press the Feed button for more
than one second.
The printer starts printing instructions.
4
After the printing has been completed, press the Feed button three
times.
5
Then press the Feed button for more than one second.
The printer starts printing instructions.
After one setting has been completed, the printer stores the setting and then starts initializing.
After that, the printer returns to the normal mode.
For detailed information about memory switches (customized value), see "Setting the Mem-
ory Switches (Customized Value)" on page 47.
To Next Page
Loading...
Need help?
General