48
Functions
Setting the paper width
•80 mm (initial setting)
•58 mm
Setting the print density
Selectable from levels 1 to 13 (70% 130%)
Setting the multi-tone print density
Selectable from levels 1 to 13 (70% 130%) (initial setting: level 7)
Setting the print speed
Selectable from levels 1 to 13 (Slow Fast) (initial setting: level 13)
Setting font
•Code page: Selectable from 43 pages including user defined page
•International character set: Selectable from 18 sets
•Font A/B replacement
Be sure to install the roll paper guide when you select the 58 mm paper width. (See
"Changing the Paper Width" on page 41.)
Once you change the paper width from 80 mm to 58 mm, you cannot change it back to
80 mm.
The print density can be set with DIP switches (2-3/2-4) or the customized value. (See
"Selecting the Print Density (DIP Switches 2-3/2-4)" on page 45.) The initial setting of the
customized value is “Depends on the DIP switch settings.” If the customized value is
changed, the value set with the customized value is enabled.
First change the print density, and then configure the multi-tone print density.
If you set the density too high, the contrast becomes lower. Select the density level
checking the overall tone balance of your image.
Depending on print conditions, such as print duty and print head temperature, print speed is
automatically adjusted, which may cause white lines due to intermittent print (the motor
sometimes stops). To avoid this, keep the print speed constant by setting it lower.
To Next Page
Loading...
Need help?
General