Chapter 2 Setup
45
2
Selecting the Print Density (DIP Switches 2-3/2-4)
Print density SW 2-3 SW 2-4
Do not set ON ON
Print density (standard) OFF OFF
Print density (darker than standard) ON OFF
Print density (dark) OFF ON
If the print density is set to “Darker than standard” or “Dark” level, printing speed may be
reduced.
The print density can be set with DIP switches (2-3/2-4) or the customized value. (See
"Setting the Memory Switches (Customized Value)" on page 47.) The initial setting of the
customized value is “Depends on the DIP switch settings.” If the customized value is
changed, the value set with the customized value is enabled.
To Next Page
Loading...
Need help?
General