382
Paper Ejection Problems
Parent topic: Solving Problems
Paper Feeding Problems
If you have problems feeding paper, try these solutions:
• Make sure the paper cassette is inserted all the way in the printer.
• Make sure the paper type setting matches the type of paper you loaded.
• If paper does not feed correctly, remove and reload it in the cassette and adjust the edge guides.
Make sure the paper stack is not above the tab on the edge guides inside the cassette.
• If multiple pages feed at once, remove the paper, fan the edges to separate the sheets, and reload it.
• If multiple sheets continue to feed at once, load one sheet of paper at a time or load new paper.
• Do not load more than the recommended number of sheets.
• Make sure your paper meets the specifications for your product.
• If paper jams when you print on both sides of the paper, try loading fewer sheets.
• If a paper out error occurs when paper is loaded in the paper tray, reload the paper in the center of the
paper tray.
• For best results, follow these guidelines:
• Use new, smooth, high-quality paper that is not curled, creased, old, too thin, or too thick.
• Load paper in the cassette printable side down.
• Load paper in the paper tray printable side up.
• Load paper in the correct direction and slide the edge guides against the edges of the paper.
• Follow any special loading instructions that came with the paper.
Note: Your product will not operate properly while tilted at an angle. Place it on a flat, stable surface
that extends beyond the base of the product in all directions.
Parent topic: Solving Paper Problems
Related references
Paper Jam Problems
Paper Loading Capacity
Paper Specifications
To Next Page
Loading...
Need help?
General
