c
Important:
When Wi-Fi Direct (Simple AP) connection disabled, all computers and smart devices connected to the printer in
Wi-Fi Direct (Simple AP) connection are disconnected.
Note:
If you want to disconnect a specic device, disconnect from the device instead of the printer. Use one of the following
methods to disconnect the Wi-Fi Direct (Simple AP) connection from the device.
❏ Disconnect the Wi-Fi connection to the printer's network name (SSID).
❏ Connect to another network name (SSID).
1.
Select Wi-Fi Setup on the home screen.
To select an item, use the
u
d
l
r
buttons, and then press the OK button.
2.
Select Wi-Fi Direct.
3.
Press the OK button to proceed.
4.
Press the OK button to proceed.
5.
Press the
button to display the setting screen.
6.
Select Disable Wi-Fi Direct.
7.
Check the message, and then press the OK button.
Changing the Wi-Fi Direct (Simple AP) Settings Such as the SSID
When a Wi-Fi Direct (Simple AP) connection is enabled, you can change the Wi-Fi Direct settings such as the
network name and the password.
1.
Select Wi-Fi Setup on the home screen.
To select an item, use the
u
d
l
r
buttons, and then press the OK button.
2.
Select Wi-Fi Direct.
3.
Press the OK button to proceed.
4.
Press the OK button to proceed.
5.
Press the
button to display the setting screen.
6.
Select the menu item that you want to change.
You can select the following menu items.
In These Situations
>
Connecting a Smart Device and Printer Directly (Wi-Fi Direct)
>
Changing the Wi-Fi Direct (
…
130
To Next Page
Loading...
Need help?
General
