The density setting is high when sending faxes.
Select Fax > Menu > Scan Settings > Density, and then lower the setting.
Received Fax Quality is Poor
The Image Quality of Received Faxes is Poor
e following causes can be considered.
ECM setting is disabled.
Select Settings > Fax Settings > Basic Settings and enable the ECM setting on the printer's control panel. is
may clear errors that occur due to connection problems. Note that the speed of sending and receiving faxes may be
slower than when ECM is disabled.
The image quality setting is low on the sender's fax machine.
Ask the sender to send faxes at a higher quality.
Cannot Select Paper Type or Paper Source in Printer Driver
A genuine Epson printer driver has not been installed.
Solutions
If a genuine Epson printer driver (EPSON XXXXX) has not been installed, the available functions are
limited. We recommend using a genuine Epson printer driver.
An Error Code is Displayed on the LCD Screen
A code is displayed on the LCD screen if there is an error or information that requires your attention. If a code is
displayed, follow the solutions below to solve the problem.
Code Situation Solutions
E-01 A printer error has occurred. Open the scanner unit and remove any paper or protective material
inside the printer. Turn the power o and on again.
E-02 A scanner error has occurred. Turn the power o and on again.
Solving Problems
>
An Error Code is Displayed on the LCD Screen
175
To Next Page
Loading...
Need help?
General
