The paper is moist or damp.
Solutions
Load new paper.
Static electricity is causing sheets of paper to stick to each other.
Solutions
Fan the paper before loading. If the paper still does not feed, load one sheet of paper at a time.
Multiple sheets of paper feed at the same time during manual 2-sided printing.
Solutions
Remove any paper that is loaded in the paper source before you reload the paper.
Paper Out Error Occurs
Paper is not loaded in the center of the rear paper feeder.
Solutions
When a paper out error occurs although paper is loaded in the rear paper feeder, reload paper in the
center of the rear paper feeder.
Paper is Ejected During Printing
Letterhead is not selected as the paper type.
Solutions
When you load letterhead paper (paper on which information such as the sender's name or corporation
name are pre-printed in the header), select Letterhead as the paper type setting.
Original Does Not Feed in the ADF
e following causes can be considered.
Originals that are not supported by the ADF are being used.
Solutions
Use originals supported by the ADF.
& “ADF Specications” on page 227
The originals are loaded incorrectly.
Solutions
Load originals in the correct direction, and slide the ADF edge guide against the edge of the originals.
Solving Problems
>
Cannot Print, Scan, or Fax
>
Paper Does Not Feed Properly
154