B
ACDEFGSERVICE
41
F5 Fitting the Fascia Panels
To avoid scratches or knocks to the fascia panels of this heater, they must be fitted at the
conclusion of the installation process, after wall linings are in place.
NOTE: Never rub the fascia.
Step 1: Ensure the plastic spacer is placed on
the thread of the studs.
Step 2: Screw and tighten the 4 studs with
spacers onto the back of the fascia.
Step 3: Rivet the 4x spring clips onto the chassis
of the appliance as shown
Step 4: After the 10-15mm thick wall has been
finished, the fascia clips onto the appliance as shown.
NOTE: wall linings larger than 10mm may require the
‘Linear Trim’ available from your local dealer to hide any
exposed wall lining.
To Next Page
Loading...
