B
ACDEFGSERVICE
S5 Replacing a Remote Control
If the wireless control becomes lost or damaged, a new one can be
ordered from any Escea retail agent. When you have the new remote,
the following procedure needs to be followed to “teach” the remote to
communicate with the fire.
1. Ensure the fire and remote are set to “OFF” (only the time is
displayed on the remote).
2. While the remote is in its “OFF” mode with only the time showing
on the display, press the MINUS, PLUS and FAN BOOST buttons
simultaneously (as shown right) until the characters “03” light up on
the display. Release the buttons and the remote will count down and display “GO”. The screen
will then display all characters and should be reading 00. This will put the remote into test
mode.
NOTE: if the digits start counting then the remote is already paired.
3. Press and hold the MINUS button until the two large temperature digits reading 00 start
to flash slowly. Release the MINUS
button. The remote control is now
ready to be addressed to the fire.
4. Press and hold the auxiliary on/o
button on the fireplace for a minimum
of ten seconds, or until the two large
temperature digits start counting
upwards from 00 to 99 repeatedly.
NOTE: Pressing the auxiliary button on/
o button will start the fire. Once the
remote control is counting the fire can be
turned o by pressing the red auxiliary
button again.
5. Press the large power button in the middle of the remote control to exit the test mode and
return to normal operation. The remote should only be displaying the time. Check the fire will
start using the remote control by pressing the large power button. Turn it o again using the
remote control.
6. The fire is now connected to the new remote control.
To Next Page
Loading...
