IP Server 900 Programming Manual Function 3: Station programming
F.50
Function 376: ESI Video Adapter programming
Important: ESI Video Adapter programming can be done only by using the local Web page which is accessible
under Function 376 in IP Server 900 Web ESI System Programmer. This local Web page has no
connection to the IP Server 900. Therefore, some information that is entered in the local Web page —
specifically, IP addressing — must also be re-entered in Function 376.
ESI strongly recommends using DHCP when initially connecting the ESI Video Adapters to your
network. Once connected, you’ll need to assign a static IP address to each Video Adapter. The
programming steps in this document are based on using DHCP. However, if DHCP isn’t an option for
you, refer to “Finding ESI Video Adapters when not using DHCP” in the ESI Video Adapter Installation
and Programming Manual (ESI # 0450-1241) for instructions on locating the adapters on your LAN.
Warning: Only those programming fields discussed in this manual are supported by ESI. Therefore, ESI will not
provide technical support for video programming settings not discussed in this manual. (Standard ESI
Technical Support Center procedure when receiving a call regarding any undocumented Video Adapter
programming fields will be to reset the Video Adapter to its default settings.)
ESI Video Adapter programming involves connecting to the Video Adapter via the local area network (LAN)
and setting certain parameters in the Video Adapter. During these programming steps, you are connecting
directly to the Video Adapter via the LAN and not through the ESI cabinet’s NSP.
1. Plug in the Video Adapter’s power supply and connect the Video Adapter to the LAN, using a standard
Ethernet cable.
2. Connect to IP Server 900 Web ESI System Programmer and access Function 376 for the site where the
Video Adapter will be used. When you are initially connecting to the Video Adapter, Function 376 will
appear blank.
(Continued)
To Next Page
Loading...
