IP Server 900 Programming Manual Function 8: IP programming
L.11
5. Enter the remote-access IP address for the location’s ESI system. This is the public IP address or
private WAN address used for remote access to the location’s system. Enter the address in dotted-
quad notation, using the # key as the dot between the octets. Press # again when finished.
701 HOU RMT IP
_
6. Enter the UDP port number assigned to the location’s ESI system. Press # to confirm.
701 HOU PBX UDP
7. Use the scroll keys to select the local IP/ASC Module that will service this location.
Note: If using more than one IP/ASC Module for Esi-Link, you should evenly distribute remote location
assignments between the two IP/ASC Modules.
8. Press # to confirm (and complete the Function 832 entries).
SELECT CARRIER
1 >
Function 833: Deleting an Esi-Link location
This function is used to delete previously entered information about Esi-Link sites. Enter the location number
to be deleted and press # to confirm.
ESI-LINK LOC
NUMBER? _
When prompted to confirm deletion, press 1. (To cancel deletion, press any other key.)
1 TO DEL LOC
701 HOUSTON
Function 834: Programming Esi-Link publish
Each IP Server 900 can publish (or transmit) up to 30 lamp appearance updates to the other Esi-Link locations.
A combination of local extensions, departments, and/or virtual mailboxes can be programmed to be published.
When programmed on a programmable feature key at another Esi-Link location, lamp appearance for numbers
on the Esi-Link publish list will automatically update.
Use the up and down arrow keys to scroll through the list. An entry can be programmed by entering an
extension number or department group number. A mailbox can be entered by pressing VOICE MAIL followed
by the mailbox number. Press # to confirm the entry.
To remove an entry from the list, use the up and down arrow keys to scroll to that entry and press HOLD to
delete, or enter a new number or mailbox.
To Next Page
Loading...
