IP Server 900 Programming Manual Function 1: System function programming
D.12
Field 3: Selectable numbering plan template
Warning: Changes to this parameter will result in system initialization, which will erase all programming, voice
messages, greetings, and recordings. System programming backups that are of a different
numbering plan range than the one selected cannot be restored.
Note: If a three-digit dial plan is used, the IP Server 900’s full capacity cannot be attained (see page
“Selectable numbering plan,” page C.2).
This parameter allows the installer to select one of nine pre-defined ranges of extension numbers (see
“Selectable numbering plan,” page C.2). However, regardless of which extension numbering range is
selected, feature codes, and CO line groups access numbers will stay the same. Press a scroll key to
select a new numbering plan, or press # to continue. If you select a new numbering plan, you will be
prompted to initialize the system by entering the Installer password.
Note: Initialization will take several minutes to complete.
Ranges: (See page C.3.) Default: 100.
Field 4: In/out DSS lamp
When a station is in off-premises mode
1
or the station is set to DND, any other station with a programmable
feature key set as a DSS key for that station will light the key amber. This parameter controls how the key
appears amber:
Key’s amber lighting if phone is in this mode. . .
Setting DND Off-premises
Both solid Solid Solid
DND wink Slow blink Solid
Out office wink Solid Slow blink
Use the scroll keys to select and press # to confirm.
Default: Both solid.
1
For more information, see the ESI Presence Management Installation Manual (ESI # 0450-0792).
To Next Page
Loading...
