IP Server 900 Programming Manual Function 1: System function programming
D.11
Function 169: System feature activation and dial plan selection
Field 1: Tenant service
Enables/disables tenant service. When tenant service is enabled, stations and departments must be
assigned to one of eight tenants in Functions 21, 31, or 33. Tenant service affects:
• Function 21 (CO line assignment, page E.1)
• Function 225 (pilot number translation table, page E.32)
• Function 31 (extension definition and routing, page F.2)
• Function 33 (department programming, page F.28)
• Function 4 (auto attendant programming, page G.1)
• Function 63 (MOH programming, page I.3)
Default: Disabled.
WARNING: When tenant service is enabled, ID branches 2 through 8 (see “Auto attendant programming,”
beginning on page G.1) will be initialized for each tenant’s main menu branch.
Field 2: CO line tenant check
Note: Offered only if tenant service is enabled in Field 1.
Controls two functions. If CO line tenant check is enabled:
1. When a CO line is placed on hold, the HOLD key LED flashes only on stations whose tenant
matches that CO line’s tenant.
1
2. When a station user presses the HOLD key to retrieve a call, the display shows only the CO lines
on hold whose tenant matches that station’s tenant.
Default: Disabled.
(Continued)
1
If Function 163, field 5, is enabled. See page D.6.
To Next Page
Loading...
