IP Server 900 Programming Manual Function 3: Station programming
F.6
5. Enter the day-mode destination for doorphone calls. This destination will be called when someone
presses the CALL key on the RFID Reader while the system or tenant is in day mode.
(For no day-mode destination, press HOLD.
1
)
Default: Extension 100.
Select a station, mailbox, or branch ID by pressing a scroll key and then entering a new value.
Press # to continue.
X123 RFID DOOR
DAY: 100
6. Enter the night-mode destination for doorphone calls. This destination will be called when someone
presses the CALL key on the RFID Reader while the system or tenant is in night mode.
(For no night-mode destination, press HOLD.)
Default: Extension 100.
Select a station, mailbox, or branch ID by pressing a scroll key and then entering a new value.
Press # to continue.
X123 RFID DOOR
NIGHT: 100
ESI Presence Management local IP RFID Reader assignment
Important: If necessary, consult the ESI Presence Management Installation Manual (ESI # 0450-0792).
1. Enter the extension number of the IP RFID Reader to be programmed and press # to continue.
STATION PROG
EXT: 114
2. Use the scroll keys to select LOCAL IP READER and press # to continue.
X114 TYPE
LOCAL IP READER
3. Now you’ll enter the local IP RFID Reader’s MAC address, which appears on the second line of the IP
RFID Reader’s display when the device is powered-up. The MAC address is a 12-character
alphanumeric address, the first six characters of which will always be 00 30 4D (of course, the display
below is merely for use as an example and shouldn’t be assumed to show the address you’ll be
entering). Enter the complete 12-character alphanumeric address. If programming using an ESI
desktop IP phone, use the first six programmable feature keys to enter the letters A, B, C, D, E, or F,
respectively.
X114 MAC ADDRESS
>
(Continued)
1
If no day/night destination is selected, CALL doesn’t appear on the RFID Reader display.
To Next Page
Loading...
