IP Server 900 Programming Manual Function 3: Station programming
F.5
ESI Presence Management digital RFID Reader assignment
Important: Before a digital ESI Presence Management RFID Reader can be programmed, it must first be connected
to a digital station port on a DKT8 Module for proper operation. If necessary, consult the ESI Presence
Management Installation Manual (ESI # 0450-0792).
1. Enter the extension number of the RFID Reader to be programmed and press # to continue.
STATION PROG
EXT: 123
2. Enter the name of the RFID Reader. The name can be up to 10 characters long. Suggested names
include the name of the entrance (“MAIN LOBBY”) or room (“STORAGE”) near which the RFID Reader
is mounted.
Press # to continue.
X123 READER NAME
NAME:
Notes: For instructions on entering alphanumeric characters, see page C.2.
If using an ESI system on which tenanting either isn’t enabled or isn’t available, skip to step 4.
3. Enter the tenant and press # to continue.
1
X123 READER NAME
TENANT: 1
4. Select the RFID Reader operation mode:
• Entrance/exit — Used for entry doors into buildings or suites. Supports presence status, phone
control, and attendance records. (Default.)
• Access only — Used for doors to secure areas. Doesn’t provide in and out status, Personal Call
Routing, or attendance records.
Both modes support remote door unlocking, automatic door control using electronic keys, and
doorphone operation.
Select the desired RFID Reader operation mode and press # to continue.
X123 DOOR NAME
ENTRANCE/EXIT >
(Continued)
1
You’ll see this prompt only if the ESI system has shared-office tenanting enabled in Function 169.
To Next Page
Loading...
