IP Server 900 Programming Manual Function 3: Station programming
F.10
11. Select the IP RFID Reader operation mode:
• Entrance/exit — Used for entry doors into buildings or suites. Supports presence status, phone
control, and attendance records. (Default.)
• Access only — Used for doors to secure areas. Doesn’t provide in and out status, Personal Call
Routing, or attendance records.
Both modes support remote door unlocking, automatic door control using electronic keys, and
doorphone operation.
Select the desired IP RFID Reader operation mode and press # to continue.
X115 DOOR NAME
ENTRANCE/EXIT >
12. Enter the day-mode destination for doorphone calls. This destination will be called when someone
presses the CALL key on the IP RFID Reader while the system or tenant is in day mode.
(For no day-mode destination, press HOLD.
1
)
Default: Extension 100.
Select a station, mailbox, or branch ID by pressing a scroll key and then entering a new value.
Press # to continue.
X115 RFID DOOR
DAY: 100
13. Enter the night-mode destination for doorphone calls. This destination will be called when someone
presses the CALL key on the IP RFID Reader while the system or tenant is in night mode.
(For no night-mode destination, press HOLD.)
Default: Extension 100.
Select a station, mailbox, or branch ID by pressing a scroll key and then entering a new value.
Press # to continue.
X115 RFID DOOR
NIGHT: 100
1
If no day/night destination is selected, CALL doesn’t appear on the RFID Reader display.
To Next Page
Loading...
