IP Server 900 Programming Manual Function 3: Station programming
F.9
7. Enter the remote IP RFID Reader’s UDP port. It doesn’t have to be the same as for the IP PBX (as
programmed in Function 81). The UDP port for the IP RFID Reader must be one that the remote WAN
gateway can program as “open,” and must not be already assigned to another device at the remote site.
Important: The remote gateway will have to be programmed to recognize that traffic destined for that UDP
port should be allowed to pass through its security system.
If the remote gateway can’t open the UDP port — or if that port is already open but designated for
another device — the Installer can choose any other UDP port number, 10000–65000, inclusive.
X115 UDP PORT
59301
8. Enter the IP address that will be used for remote access to the IP Server 900. The display will default to
the IP address entered in Function 82. If a remote IP RFID Reader will use this address to connect to
the system, press # to confirm; if a remote IP RFID Reader will use an alternate IP address to connect
to the system, enter that address and press # to confirm.
The message SAVE PARAMETERS? will appear on the display. If you have correctly entered the IP
addressing parameters (steps 1–7), press # to program the parameters for any remote IP RFID Reader;
or, to abort programming, press to restore the system parameters to their previously set values.
RMT ACCESS IP
209.164.111.1
9. Enter the name of the IP RFID Reader. The name can be up to 10 characters long. Suggested names
include the name of the entrance (“MAIN LOBBY”) or room (“STORAGE”) near which the IP RFID
Reader is mounted.
Press # to continue.
X115 READER NAME
NAME:
Notes: Refer to the ESI system’s Installation Manual for instructions on entering alphanumeric characters.
If using an ESI system on which tenanting either isn’t enabled or isn’t available, skip to step 11.
10. Enter the tenant and press # to continue.
1
X115 READER NAME
TENANT: 1 >
(Continued)
1
You’ll see this prompt only if the ESI system has shared-office tenanting enabled in Function 169.
To Next Page
Loading...
