ESI 900 - Page 79

IP Server 900 Programming Manual Function 3: Station programming
F.12
5. Tenant — Assign the extension to a tenant. This is used to direct-dial operator (0) calls to the tenant’s
operator destination; it’s also used to play the tenant’s MOH source when calls are placed on hold.
Note: To view and assign an tenant, tenant service must be enabled in Function 169.
Default: 1.
6. CO line/ring down — For fax, modem, or phone, select the desired line group — 9, 8, or 71–76.
Default: 9.
If door phone is selected, an extension number is entered as a ring-down destination.
Default: First extension number in the selected dial plan.
7. and 8. Call forward busy/no answer for day and night modes — The ports can be set to call forward
busy/no answer to an extension, department, mailbox or a branch ID for day mode and differently for
night mode.
Default: ID9999 (automatic disconnect).
The default settings for each analog port type are shown below:
1.
Ext.
2.
Type
3.
Name
4.
Caller ID
5.
Tenant
6.
CO
7.
CF day
8.
CF night
111 EXT Phone 1 9 MB106 MB106
RINGER Ringer*
FAX Fax 1 9 ID9999 ID9999
SERVER Server 1 9 ID9999 ID9999
DOOR Door* 1 X100 ID9999 ID9999
MODEM Modem 1 9 ID9999 ID9999
* Name can be changed in Function 32 (see page F.23).