EasyManua.ls Logo

Espressif ESP32-S2 - Page 1123

Espressif ESP32-S2
1695 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Chapter 2. API Reference
CONFIG_OTA_ALLOW_HTTP
Allow HTTP for OTA (WARNING: ONLY FOR TESTING PURPOSE, READ HELP)
Found in: Component config > ESP HTTPS OTA
It is highly recommended to keep HTTPS (along with server certificate validation) enabled. Enabling this
option comes with potential risk of: - Non-encrypted communication channel with server - Accepting
firmware upgrade image from server with fake identity
Default value:
No (disabled)
ESP HTTPS server Contains:
CONFIG_ESP_HTTPS_SERVER_ENABLE
CONFIG_ESP_HTTPS_SERVER_ENABLE
Enable ESP_HTTPS_SERVER component
Found in: Component config > ESP HTTPS server
Enable ESP HTTPS server component
Hardware Settings Contains:
MAC Config
Sleep Config
MAC Config Contains:
CONFIG_ESP32S2_UNIVERSAL_MAC_ADDRESSES
CONFIG_ESP32S2_UNIVERSAL_MAC_ADDRESSES
Number of universally administered (by IEEE) MAC address
Found in: Component config > Hardware Settings > MAC Config
Configure the number of universally administered (by IEEE) MAC addresses. During initialization,
MAC addresses for each network interface are generated or derived from a single base MAC address.
If the number of universal MAC addresses is Two, all interfaces (WiFi station, WiFi softap) receive a
universally administered MAC address. They are generated sequentially by adding 0, and 1 (respectively)
to the final octet of the base MAC address. If the number of universal MAC addresses is one, only WiFi
station receives a universally administered MAC address. Its generated by adding 0 to the base MAC
address. The WiFi softap receives local MAC addresses. Its derived from the universal WiFi station
MAC addresses. When using the default (Espressif-assigned) base MAC address, either setting can
be used. When using a custom universal MAC address range, the correct setting will depend on the
allocation of MAC addresses in this range (either 1 or 2 per device.)
Available options:
One (ESP32S2_UNIVERSAL_MAC_ADDRESSES_ONE)
Two (ESP32S2_UNIVERSAL_MAC_ADDRESSES_TWO)
Sleep Config Contains:
CONFIG_ESP_SLEEP_FLASH_LEAKAGE_WORKAROUND
CONFIG_ESP_SLEEP_GPIO_RESET_WORKAROUND
CONFIG_ESP_SLEEP_POWER_DOWN_FLASH
CONFIG_ESP_SLEEP_PSRAM_LEAKAGE_WORKAROUND
Espressif Systems 1112
Submit Document Feedback
Release v4.4

Table of Contents