Chapter 2. API Reference
CONFIG_MBEDTLS_ECJPAKE_C
Elliptic curve J-PAKE
Found in: Component config > mbedTLS > CONFIG_MBEDTLS_ECP_C
Enable ECJPAKE. Needed to use ECJPAKE-xxx TLS ciphersuites.
Default value:
• No (disabled)
CONFIG_MBEDTLS_ECP_DP_SECP192R1_ENABLED
Enable SECP192R1 curve
Found in: Component config > mbedTLS > CONFIG_MBEDTLS_ECP_C
Enable support for SECP192R1 Elliptic Curve.
Default value:
• Yes (enabled) if (CONFIG_MBEDTLS_ATCA_HW_ECDSA_SIGN || CON-
FIG_MBEDTLS_ATCA_HW_ECDSA_VERIFY) && CONFIG_MBEDTLS_ECP_C
CONFIG_MBEDTLS_ECP_DP_SECP224R1_ENABLED
Enable SECP224R1 curve
Found in: Component config > mbedTLS > CONFIG_MBEDTLS_ECP_C
Enable support for SECP224R1 Elliptic Curve.
Default value:
• Yes (enabled) if (CONFIG_MBEDTLS_ATCA_HW_ECDSA_SIGN || CON-
FIG_MBEDTLS_ATCA_HW_ECDSA_VERIFY) && CONFIG_MBEDTLS_ECP_C
CONFIG_MBEDTLS_ECP_DP_SECP256R1_ENABLED
Enable SECP256R1 curve
Found in: Component config > mbedTLS > CONFIG_MBEDTLS_ECP_C
Enable support for SECP256R1 Elliptic Curve.
Default value:
• Yes (enabled)
CONFIG_MBEDTLS_ECP_DP_SECP384R1_ENABLED
Enable SECP384R1 curve
Found in: Component config > mbedTLS > CONFIG_MBEDTLS_ECP_C
Enable support for SECP384R1 Elliptic Curve.
Default value:
• Yes (enabled) if (CONFIG_MBEDTLS_ATCA_HW_ECDSA_SIGN || CON-
FIG_MBEDTLS_ATCA_HW_ECDSA_VERIFY) && CONFIG_MBEDTLS_ECP_C
CONFIG_MBEDTLS_ECP_DP_SECP521R1_ENABLED
Enable SECP521R1 curve
Found in: Component config > mbedTLS > CONFIG_MBEDTLS_ECP_C
Enable support for SECP521R1 Elliptic Curve.
Default value:
Espressif Systems 1200
Submit Document Feedback
Release v4.4
To Next Page
Loading...