58 SmartFade ML v3.0.1 User Manual
Sequences
A Sequence is a list of up to 24 steps that can be recorded to and played back from faders
13-24. Each fader page carries up to 12 sequences and there are 12 fader pages - so a
total of 144 sequences can be recorded. Faders containing sequences in MEMS mode
have yellow bump buttons
Each step of a sequence can contain one of two items:
• One single dimmer or device intensity channel from INT A, INT B or DEVICE INT.
• A memory from any of the 12 fader pages
Step Times
Sequence steps can have three times; Up , Down and Wait time. There is also an override
Rate and Fade factor. See “Sequence & Stack Times” on page 74.
Playback modes
Sequences can be played back as a loop (chase), one-shot or manually. See “Run Modes”
on page 73.
To Next Page
Loading...
