72 SmartFade ML v3.0.1 User Manual
Copy a Sequence
Delete a Sequence or the Stack
It’s possible to delete any single sequence (or memory) or the stack directly.
Action Console Feedback
1. Activate Copy mode This button lights up. All buttons with content
will blink at full (press CLEAR to exit).
2. Select source sequence
(change page if neces-
sary).
... When this button is pressed, all possible tar-
gets for this copy operation will blink. Empty
ones blink at full, occupied ones are dimmed.
3. Select target ... As soon as the button is pressed, the source
sequence is recorded. The console will auto-
matically return to it’s previous fader mode.
Action Console Feedback
1. Activate DELETE mode The console will enter delete mode and you
can select any bump button with a Sequence
(or memory) or the Stack as a target (press
CLEAR to exit).
2. Select target sequence
or the Stack
... or When you press the bump or Stack button, it
the content is deleted, and the console will
return to the previous mode. You can press
UNDO.
To Next Page
Loading...
Need help?
General
