78 SmartFade ML v3.0.1 User Manual
Edit Linear Effects
If an empty effect is started, it will automatically go into Edit Effect mode.
Action Console Feedback
1. Select Edit Effect mode This button lights up. The Effect select but-
tons light up full, empty ones are dimmed.
2. Select Effect to edit ... The selected effect select button will blink.
The select parameter menu is opened in the
right LCD.
Select what parameter type the effect will be
applied to by pressing a bump button in
PARAM 1 or PARAM 2. The display will
switch to effect editing when this is done.
Menu choice Console Feedback
Speed Wheel 1 Set speed 0-100
Depth Wheel 2 Set depth 0-100
Table Wheel 3 Select table
1 Morse
2 Strobe
3 Flicker
4 Lightning
5 Wander
6 Sparkle
7 Mountain
8 Skyline
9 Saw
10 Cosine
11 Ramp
To Next Page
Loading...
Need help?
General
