Euphonix MC Media Application Controller User Manual

Euphonix Media Application Controller Operation Manual Installation and Configuration
19
The MC presents a list of three options to install:
• MCApp, EuCon runtime, etc. - This is the main MC software application.
It is grayed out since it must be installed for the MC to function properly.
• MC PC104 Driver, hardware support, firmware - This installs the actual
hardware driver the EuConMC uses to control the MC surface. DO NOT
UNCHECK THIS OR YOUR MC WILL NOT FUNCTION.
• CM408T Software + Update Server - This installs the Firmware Updates
server, which updates the CM408T module firmware. See 2.2.4 Firmware
Update Server (System 5-MC only).
8. Press Next on the remaining dialogs in the Install Wizard.
9. Reboot the MC when the Wizard finishes.
2.2.4 Firmware Update Server (System 5-MC only)
If CM408T Software + Update Server is checked, the Firmware Update Server
launches after the EuConMC installation completes. The CM408T modules will then
prompt to be updated. If they do not, reboot them and they will connect to the Firmware
Update Server. Press the Y key on each CM408T after the update prompt appears. Each
CM408T will apply the update, automatically reboot, and be ready to operate. After all
CM408T modules are updated, quit the Update Server.

Euphonix MC Media Application Controller Specifications

General

Brand	Euphonix
Model	MC Media Application Controller
Category	Recording Equipment
Language	English