Euphonix MC Media Application Controller User Manual

Euphonix Media Application Controller Operation Manual Installation and Configuration
26
If the MC reboots while connected to a workstation, MCApp re-launches, then the MC
re- connects to the previously assigned workstation without needing to press the Work-
station button.
2.3.6 Visit Workstation
A workstation may be visited by pressing Shift + Workstation 1–4 key. Visiting is a
quick way to deliver keyboard and trackball commands to the visited Workstation with-
out actually performing a EuCon-aware workstation switch. For example, while work-
ing in Nuendo, you can quickly switch to a Pro Tools workstation to dismiss an on-
screen dialogue or do a quick edit.
Visiting also causes the (optional) Ontrak USB to GPI (for DVI switching) to switch to
the selected Workstation number.
2.3.7 Modules (System 5-MC Only)
Figure 2-7 Preferences-Modules Touchscreen
This Touchscreen assigns CM408T modules to the MC. All available CM408Ts are
listed on the right under All Online. Currently assigned CM408Ts are listed on the left
under Assigned to this MC. This is the order in which the MC assigns channel strips
to the modules.

Euphonix MC Media Application Controller Specifications

General

Brand	Euphonix
Model	MC Media Application Controller
Category	Recording Equipment
Language	English