Euphonix Media Application Controller Operation Manual MC Preference Settings
40
To set the brightness of the Soft Keys, use the arrow keys to increase/decrease the illu-
mination (1-10):
• Blue Brightness: Sets the illumination for the blue Soft Keys.
• Green/Orange/Red Brightness: Sets the illumination for the Green/Orange/
Red Soft Keys.
• Contrast: Changes the contrast on all soft keys.
• Dim Level: Sets the illumination for dimmed Soft Keys.
To set the button timing of the Soft Keys, use the arrow keys to increase/decrease the time:
• Latch Timeout: Sets the amount of time (50–500 ms) before a held-down but-
ton becomes momentary or non-latching. For example, a Solo button held
down longer than the Latch Timeout setting becomes non-latching and turns
off when released. Buttons held down for a shorter time than this setting behave
normally (i.e., turn on or off depending on their prior state).
• Repeat Delay: Sets the amount of time (250–1000 ms) before a repeatable but-
ton starts repeating its command when held down (i.e., Nudge or Zoom).
Repeat Rate: Sets the amount of time (30–400 ms) between the repeated commands
when a repeatable button is held down. The button begins repeating after being held
down for the Repeat Delay setting.
4.4 About
Figure 4-4 Preferences-About Touchscreen
This Touchscreen displays the version of the EuCon software loaded on the MC. The
EuConMC software can be upgraded by downloading the latest version from the Eu-
phonix website (see page 18 for instructions).