Euphonix Media Application Controller Operation Manual Working with Channels
67
To assign strips:
1. Press the Layouts key in the Strip Control section on the MC (top-right of the
surface) to display the Assign Touchscreen.
2. Touch the tracks in the desired assignment order.
The track numbers appear under Selection Order at the top-left.
3. Touch Insert Blank Strip at the point where a blank strip is desired.
Blank strips appear as asterisks in the selection order.
4. Touch a selected track to remove it from the order.
If the track is in the middle of the selection order, subsequent tracks shift up to
take its place.
5. When finished creating the desired Selection Order, press the Wave key on the
channel strip where the direct assigned tracks should start.
The MC automatically assigns the tracks beginning at that channel strip. Tracks
currently direct assigned to channel strips shift to the right of all the assigned
tracks.
To remove direct assignments, touch the Unassign button. If none of the selected tracks
are currently direct assigned, the Unassign button is gray and inactive.
To direct assign just one strip, press that strip’s Wave and Chan Sel keys simultaneously.
This pops up a list of track names to select on the CM408T’s display or MC Touch-
screen. To remove the direct assignment, choose None at the top of the list.
When a track is Direct Assigned to a strip, the underlying tracks, both Main and Swap,
are shifted to the right.
To Next Page
Loading...
Need help?
General
