Euphonix MC Media Application Controller User Manual

Euphonix Media Application Controller Operation Manual Studio Monitor Express (Mac)
84
Main tab controls:
• mapping of Sources created in the Sources tab (page 85) to Control Room,
Monitor A and Monitor B, also selectable from the MC Monitor section’s
Touchscreen.
• monitor level sliders, control levels to Control Room, Monitor A, Monitor B,
and correlates to the two Monitors knobs in the MC’s Monitors section.
• Cut: Select this button to cut the signal completely.
• Dim: Select this checkbox to attenuate the signal to the Dim Level set in the
Config tab (page 88).
• Fix: Select this checkbox to set the signal to the Fixed Level set on the Config
tab; correlates to MC’s Dim button (page 88).
• Phase: Select this checkbox to reverse the phase of the left channel (no surface
control for this parameter)
Only sections created in the Sources tab appear in the Source boxes (Figure 10-1). To
route a Source to a specific Monitor section, select it in the Source box for the desired
monitor output. Sources can also be selected from the MC Monitors section Setup
Touchscreen.
When the workstation and MC are connected, the changes made in this tab are reflected
in the Monitor and Control Room section on the surface, and vice versa.

Euphonix MC Media Application Controller Specifications

General

Brand	Euphonix
Model	MC Media Application Controller
Category	Recording Equipment
Language	English