EVS Broadcast Equipment SA
Issue 2.0.7.2 September 2021
54 Supervisor
Note
• Before establishing a Dyvi network, the Network Settings
and Dyvi Cluster Management procedures have to be
executed/verified on each Dyvi device.
• Every time the network address has been changed, the new
address should be labeled at the devices surface for later
convenience.
• Full functionality as described below is only accessible on
each device where the browser is connected to. If more
than one device is visible on the network, some of the
functions described below are also accessible on those
other devices in case of they should be selected on the left
side of the Main Window.
10.2 Processing Module
10.2.1 Managing the Network
To manage the network on a Dyvi Processing Module, proceed as follows:
1. Establish a network connection between your browsing Device and one
(the first) Dyvi Processing Module’s LAN1 connector.
2. Open the Browser Mozilla Firefox (preferred) or MS Internet Explorer
(V9.x or higher) and connect to the Processing Module Supervisor
using the Processing Module’s Network Address, e.g.:
http://100.10.1.91.
3. Enter the password to log into the Supervisor: dyvilive.
The browser will open the Devices Overview window of the Supervisor.
Note
Browsing Device can be the GUI or any PC in the network with
IP address in correct range.
To Next Page
Loading...
