EXCELL PRECISION CO., LTD
PW Service Manual SME300000016
10
Press
UNITS
key
CHAPTER 2 SERVICE MODE ACCESS
n Set the jumper SWA1 on the main board to the ADJ position (EEPROM UNLOCKED).
Switch the PW on. The display shows .
n When finished, set the jumper SWA1 back to the LOCK position.
n If the jumper SWA1 is returned to the LOCK position during calibration, the PW exits the
service mode automatically.
⇒ Capacity Configuration ⇒ Function Setting
⇒ Weighing Calibration ⇒ Gravity Setting
⇒ Linearity Calibration
Press
ON/ZERO
key
To Next Page
Loading...
