Accessing Your Unit Remotely
218 FTB-2/FTB-2 Pro and FTB-4 Pro
Working With VNC
Connecting to Your Unit with VNC
Once the UltraVNC Viewer is installed on your computer, you are ready to
access your unit remotely.
To connect to your unit with UltraVNC:
1. Connect both the computer and your unit to the same network and
make sure they can “see” each other as network restrictions might
prevent them from communicating.
If you want to use an Ethernet network, connect an RJ-45
(network) cable to the unit’s RJ-45 port located on its right panel.
If you want to use a wireless network, see Connecting to a Wireless
Network on page 178.
You can also create a Private Area Network with your Bluetooth
®
device (see Transferring Data Using the Bluetooth Technology on
page 171).
2. Turn on both the computer and the unit.
3. On your unit, ensure that ToolBox X is open.
4. At the bottom of the button bar, tap .
ООО "Техэнком" Контрольно-измерительные приборы и оборудование www.tehencom.com
To Next Page
Loading...
Need help?
General
