Communicating Through TCP/IP Over Telnet
FTB-2/FTB-2 Pro and FTB-4 Pro 483
Internal Commands of the TCP/IP over Telnet Protocol
CONNECT LINS
Description This command allows to inform other sessions that
you are connected to one or more instruments.
Syntax The syntax of the command vary according to the
type of platform you are using.
For IQS-600 and FTB-500:
CONNECT LINS<Unit_Number><Slot_Number>
You must specify the unit number and the slot
number identifying the module to which the
session will connect.
For LTB-1, LTB-8, FTB-2, FTB-2 Pro, and FTB-4 Pro:
CONNECT LINS<Logical_Instrument_Number>
You must specify the logical instrument number
corresponding to the module to which the
session will connect. This number is configurable
from the Remote Control Configuration
application.
ООО "Техэнком" Контрольно-измерительные приборы и оборудование www.tehencom.com
To Next Page
Loading...
Need help?
General
