Test Setup - Test Configurator, Timer, and System
NetBlazer 133
EtherBERT, FC BERT, BERT (CPRI), and Unframed BERT
Shaping
TX Rate allows the selection of the transmission rate in percentage of
utilization (100 percent by default), Mbit/s, Gbit/s, Frame/s, or IFG for
Ethernet; Mbit/s, Gbit/s, MB/s, or % for Fibre Channel. For Ethernet, the
maximum percentage is 105 percent depending on the frame size
selected.
Enable TX check box is automatically selected when starting the test
allowing stream generation; automatically cleared when the test stops.
The Enable TX check box may also be selected or cleared while the
test is running. Not available for FC BERT.
To Next Page
Loading...
