EasyManua.ls Logo

Explorer GT 50 - Maintenance and Adjustment Procedures; Storage Battery

Explorer GT 50
112 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
10
Maintenance and adjustment procedures
The section describes the servicing procedures for each item of the Periodic Maintenance requirements.
Storage battery
Inspect at initially 1000KM600 miles2 monthsand
every 6000KM4000 miles12 monthsthereafter
႒ Uncover seat, and then remove the battery box cap in the
Middle of helmet barrel.
႒ Disconnect negative pole line end, positive end, and then remove battery
႒ Measure the voltage between the two ends of battery with
voltage gaugecharge if the voltage is below 11,9V

Table of Contents