98
REASSEMBLY AND REMOUNTING
Reassemble and remount the rear wheel and brake in the
reverse of removal, and also carry out the following steps:
႒ Turn the punched mark on the camshaft to the
rear axle shaft side.
႒ Install the protrusion ཱ of indicator plate to the groove ི
of Camshaft.
႒ When installing the brake cam shaft, aligh the groove ཱི of
camshaft with the slit ུ of on cam shaft.
႒ When installing brake shoes, be sure to daub camshaft
with adequate grease.
CAUTION:
Be careful not to daub the camshaft with too much grease.
If grease gets on the lining, brake effectiveness will be lost.
To Next Page