EasyManua.ls Logo

Explorer GT 50 - Recharging Operation

Explorer GT 50
112 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
74
RECHARGING OPERATION
Apply multimeter to measure the voltage of battery. If the reading is below 12.0Vit should be
charged.
NOTE:
When recharging, remove the battery form the vehicle.
NOTE:
When recharging, don’t remove the sealing cap off battery top.
Recharging time0.4A or for 5 hours or 4.0A for 1 hour.
NOTE:
The current should be not more than 4A at any time.
After recharging, wait for more than 30 minutes and apply multimeter to measure the battery
voltage.
If the battery voltage is less than12.5Vplease rechare the battery again.
If battery voltage is still less than 12.5Vplease replace the battery with a new one.
When the battery is left for a long term without using, it is subject to discharge. When th scooter is
not used for more than 1 month (especially dring the winter season), recharge the battery once a
month at least.

Table of Contents