87
CALIPER AND DISC INSPECTION
Inspect the calipe cylinder bore wall or micks,scratches or
other damage.
Inspect piston for damage and wear.
Inspect each rubber part for damage and wear.
Check the disc for wear with a micrometer.Its thickness can
be checked with disc and wheel in place. Ralpace the dise if
the thickness exceeds the service limit.
Service Limit:3.5 mm (0.14 in)
With the disc mounted on the wheel, check the dids for face
runout with a dial gauge as shown.
Replace the disc if the runout exceeds the service limit.
Service Limit:0.3 mm(0.012 in)
To Next Page
Loading...