Extreme Networks ExtremeSwitching X440-G2 Series User Manual

4 Push the power supply in until the latch snaps into place.
Caution
Do not slam the power supply into the chassis.
Figure 175: Installing a 750 W AC Power Supply in an EPS-C2 Chassis
Note
If power supplies are not installed in all three slots, be sure to install a cover over each
unoccupied slot. Unoccupied slots must always be covered to maintain proper system
ventilation and EMI levels.
Repeat the procedure to install each additional power supply.
Connecting Redundant Power Cables for the EPS-C2 Chassis
The EPS-C2 chassis can use up to five 2x7-pin redundant power connectors, shown in Figure 176, which
connect the power supply to ExtremeSwitching X440-G2 and X620 switches.
Figure 176: EPS-C2 2x7 Pin Redundant Power Cable with Connector Key Tab
Installing External Power Supplies
ExtremeSwitching and Summit Switches: Hardware Installation Guide 229

Extreme Networks ExtremeSwitching X440-G2 Series Specifications

General

Form Factor	Rack-mountable
VLAN Support	Yes
Humidity	5% to 95% non-condensing
Model	X440-G2 Series
Port Type	Gigabit Ethernet
Switching Capacity	176 Gbps
Forwarding Rate	131 Mpps
Stacking	Yes, up to 8 switches
Layer Support	Layer 2/3
Operating Temperature	0°C to 50°C
Product Type	Switch
Jumbo Frames	9216 bytes
AC Power Supply	100-240 VAC, 50-60 Hz
Storage Temperature	-40°C to 70°C
Port Configuration	24 or 48 ports
Power over Ethernet (PoE)	Optional